Induction Motor MCQs Part 9
Contents
- 1 A 3-phase delta connected induction motor is carrying too heavy load and one of its fuses blows out. Afterwards the motor
- 2 A squirrel cage induction motor is not selected for which of the following case
- 3 Circle diagram for an induction motor cannot be used to find
- 4 Good power factor of an induction motor can be achieved if the average flux density in the air gap is
- 5 If the relative speed between the rotating flux of stator and rotor of the induction motor is zero
A 3-phase delta connected induction motor is carrying too heavy load and one of its fuses blows out. Afterwards the motor
A 3-phase delta connected induction motor is carrying too heavy load and one of its fuses blows out. Afterwards the motor:
- Will stop and carry heavy current causing permanent damage to its winding
- Will continue running with one burning phase
- Will continue running without any harm to the winding
- Will continue running burning its two phase
Correct answer: 1. Will stop and carry heavy current causing permanent damage to its winding
A squirrel cage induction motor is not selected for which of the following case
A squirrel cage induction motor is not selected for which of the following case:
- Maintenance cost is to be kept low
- Initial cost is the main consideration
- Higher starting torque is the main consideration
- All above considerations are involved
Correct answer: 3. Higher starting torque is the main consideration
Circle diagram for an induction motor cannot be used to find
Circle diagram for an induction motor cannot be used to find:
- Power factor
- Efficiency
- Output
- Frequency
Correct answer: 2. Efficiency
Good power factor of an induction motor can be achieved if the average flux density in the air gap is
Good power factor of an induction motor can be achieved if the average flux density in the air gap is:
- Large
- Absent
- Infinity
- Small
Correct answer: 4. Small
If the relative speed between the rotating flux of stator and rotor of the induction motor is zero
If the relative speed between the rotating flux of stator and rotor of the induction motor is zero:
- The torque produced will be very large
- The rotor will run at very high speed
- The rotor will not run
- The slip of the motor will be 5%
Correct answer: 3. The rotor will not run